Denon PRA-S10 - Disassembly Guide; Component Removal Steps

= PRA-S10
DISASSEMBLY
(For reassemble reverse disassembly.)
1. Top Cover
(1) Remove 4 screws (1) on the both sides. @)
(2) Remove 4 screws @) on the top side and 2 rear screws @) 5
(3) Detach Top Cover in arrow direction.
Top Cover
2. Front Panel
(1) Remove connectors (4) which are connected to PRE
AMP P.W.B. and Control P.W.B..
(2) Remove 4 screws 6) on the below side and 2 screws
©) on the upper side.
3) Remove 2 screws Q) on the 3T Lug.
(
(4) Pull out 2 Knobs @) and nut :
(5) Remove 2 screws on the Front Panel.
(6) Pull out Knob Shaft. Front Panel
3. Rear Panel
(1) Remove connectors @) which are connected to PRE
AMP P.W.B. and PRE COUT-2 P.W.B..
screws and 6 screws
(3) Detach the Rear Panel.
Rear Panel & q (2)