Denon S-81 - External Device Connectivity; XM Satellite Radio Connection; iPod Cable Connection

14
S-81/S-81DAB
7.1
Normal heat run
mode
・The CD heat run mode is launched. Once writing
of the TOC data is completed, press the CD
PLAY/PAUSE button. Count this as the 0th heat
run repetition.
① Play from the first to last track on disc.
② If disc being used has less than 20 tracks, play
all tracks. If disc has 21 or more tracks, skip to
final track after playback of first track has
finished.
③ After disc playback has finished, move pickup
to innermost position and open tray.
④ When loader open status detected, close tray
again, re-read TOC and start playback from
the first track on the disc.
⑤ The heat run repetition no. is incremented
(increased by 1) when the tray is opened.
⑥ Conduct ① to ⑤ repeatedly.
・ lit
① , ②
・In cases other than when is lit, same display as
during normal playback.
③
XXXX : No. of heat run repetitions
④
7.2
Automatic
mounting mode
・After CD heat run mode has started and reading
the TOC has finished, press the CD STOP/
BAND button once in the stop mode.
・TOC reading ⇒ Search for first track on disc ⇒
tray open ⇒ tray close ⇒ TOC reading ⇒
repeat. No. heat run repetitions displayed on
time display section.
・Increment the heat run repetition no. (increase by
1) at the point when the loader has finished
opening.
While tray opened
・Same as for regular heat run. See 7.1 ③ .
When tray closed
・Same as for regular heat run. See 7.1. ④
No Button name Function Display
7.1 通常ﾋｰﾄﾗﾝﾓｰﾄﾞ
・CDﾋｰﾄﾗﾝﾓｰﾄﾞが起動し、TOCREAD が完了し
た後、CDPLAY/PAUSE ﾎﾞﾀﾝを押す．この時、
ﾋｰﾄﾗﾝ繰り返し回数を 0 回目とする．
①ﾃﾞｨｽｸの先頭ﾄﾗｯｸから最終ﾄﾗｯｸまで再生す
る．
②使用ﾃﾞｨｽｸが 20 ﾄﾗｯｸ以内の場合は全ﾄﾗｯｸを
再生する．21 ﾄﾗｯｸ以上なら１ﾄﾗｯｸ目終了後、
最終ﾄﾗｯｸにｽｷｯﾌﾟする．
③ﾃﾞｨｽｸの再生終了後、ﾋﾟｯｸｱｯﾌﾟを最内周に移
動させﾄﾚｲを開く．
④ﾛｰﾀﾞｰ OPEN 状態を検出したら、再度ﾄﾚｲを
閉じ再度 TOC を読み取り後、ﾃﾞｨｽｸの先頭
ﾄﾗｯｸから再生を開始する．
⑤ﾋｰﾄﾗﾝ回数はﾄﾚｲを OPEN したところで
ｲﾝｸﾘﾒﾝﾄ ( ﾋｰﾄﾗﾝ回数を 1 つ増やす ) する．
⑥①〜⑤を繰り返し実行する．
・ を点灯
①、②
・ を点灯している以外は通常再生中と同じ表示．
③
XXXX ：ﾋｰﾄﾗﾝ繰り返し回数
④
7.2 ﾁｬｯｷﾝｸﾞﾓｰﾄﾞ
・CDﾋｰﾄﾗﾝﾓｰﾄﾞが起動し、TOCREAD が完了し
た後、停止中に CDSTOP/BAND ﾎﾞﾀﾝを 1 回押
す．
・TOC 読込み⇒ﾃﾞｨｽｸの先頭ﾄﾗｯｸをｻｰﾁ⇒
ﾄﾚｲ OPEN ⇒ﾄﾚｲ CLOSE ⇒ TOC 読込み⇒を繰り
返す。時間表示部にﾋｰﾄﾗﾝの繰り返し回数を表
示する。
・ﾋｰﾄﾗﾝ回数はﾛｰﾀﾞｰを OPEN し終えたところで
ｲﾝｸﾘﾒﾝﾄ ( ﾋｰﾄﾗﾝ回数を 1 つ増やす ) する．
ﾄﾚｲｵｰﾌﾟﾝ中
・通常ﾋｰﾄﾗﾝ時と同じ．S7.1③を参照
ﾄﾚｲｸﾛｰｽﾞ中
・通常ﾋｰﾄﾗﾝ時と同じ．S7.1④を参照
No キー名称 機能 表示