Denon UCD-250 - Using the Timer

a) USING THE TIMER
Example: Listening to the FM station preset at number 3
e Be sure to set the current time.
© Regular timer: The power can be switched on and off once every day at the same time. (Wake-up music}
® Sleep timer: The power can be set to turn off in up to 60 minutes in steps of 10 minutes using the remote control unit. (Bedtime
Press the TUNER button on
the remote control unit.
music)
Be sure to preset stations before setting the timer.
Refer to “Presetting MW, LW and FM Stations” on Page 9.
e Turn the standby switch off when not using the timer.
Press button “3” on the remote = !
control unit,
Should a power failure occur or if the power cord becomes unplugged from the power outlet, 00:00 or the time at which the power failed
will flash on the time display. if this happens, reset the current time.
{Reset the current time and timer settings. If 00:00 was displayed, also reset the stations preset on the tuner.)
The standby mark starts flashing if there is a power failure or the power cord is unplugged while the standby mark is lit. If this happens,
reset the time and the timer. {If the display reads 90:00 , aiso reset the tuner's preset channels.)
FM
Stereo
Reception
To
make
the
standby
mark
stop
flashing,
press
the
TIMER
button,
then
press
the
TIMER
or
CLEAR
button
while
“FUNC”
is
disptayed.
@
When
the
MONO/STEREO
button
is
pressed
(which
lights
the
AUTO
and
MONO
indicators)
and
an
FM
stereo
broadcast
is
received,
the
STEREO
indicetor
lights
and
the
station
is
received
in
stereo.
If
the
MONO
indicator
is
lit
by
pressing
the
MONO/STEREO
button,
the
Setting
the
Current
Time
(A
24-hour
clock
display
is
used.)
STEREO indicator goes off and the station is received in monaural.
Notes on Presetting
@ When an FM station is preset, the auto ar monaural mode is also set, so check the display before Ppresetting the station.
©
Ifa
station
is
preset
to
a
number
at
which
another
station
has
previously
been
preset,
the
previous
station
is
cleared
and
the
new
station
7 e
is preset. 7 &~ 888 8S=ragc~2
FEI wate twee ay ere se som IED
© If the power cord is unplugged, the preset memory is not cleared immediately, but will be cleared if the cord is laft unplugged over a pete — el
long period. Should this happen, preset the stations again.
Hold in the CLOCK/DISPLAY button
for 3 seconds or tonger.
Set the hours with the UP
and DOWN buttons.
wehbe
Press the ENTER/NEXT button. ] gz The minutes’ places flash.
7
Set the minutes with the UP 7 The set places flash.
and DOWN buttons. D
Press the ENTER/NEXT button
at the sound of a time signal. The display lights steadily
The time display lights steadily : and the clock starts to
and the clock starts keeping count from 0 seconds.
the time.
10
\
~*~ 10 |
7 if |
: 7 Sets
© q gam
4
NOILOSS IWHANSD
eae a a 0 ee ee OCO-O aa