Denon UDRA-70 - CASSETTE DECK OPERATION; Before Recording and Playback; Using the Tape Counter; Auto Tape Selector Mechanism

ENGLISH
CASSETTE DECK
Before Recording and Playback
This
deck
is
equipped
with
an
auto
reverse
mechanism,
so
cassette
tapes
can
be
played
and
recorded
on
both
sides
or
played
continuously
without
having
to
turn
them
over.
@ Direction of tape travel
This deck has two play buttons, one for the forward direction (front side) s
and
another
for
the
reverse
direction
(back
side).
The
side
being
played
can
Playback
on
back
side
'
Playback
on
front
side
;
:
:
(Side
which
is
visible
be
changed
during
playback
by
pressing
the
opposite
play
button.
when
loaded
ia
cassette tray.)
@ Reverse mode
Set the reverse mode switch (REV. MODE) as follows:
e One-side recording/playback mode ( —— )
In this position, only the front side or the back side of the cassette tape
is played or recorded. (The tape stops automatically when the end of
that
side
is
reached.)
Start
from
[Os|—
‘aia
—>
[Pa
Auto
stop
e
Two-side
(reverse)
recording/playback
mode
(
=
)}
front
side
In this position, when the end of the front side is reached, recording or
playback automatically switches to the back side and continues from Ainevion [Oo] ce) et rx: ) Start from
there. (The tape stops automatically when the end of the back side is back side
reached.)
e Continuous mode ( C })
Playback continues until the STOP button is pressed, but stops
Start from
automatically after both sides have been played five times. front side (ey— — —> [Pa ~~ ‘
Reverse
Auto stop 04 <+-—/-d q+/
If you start playing or recording from the back side, the tape will stop
automatically at the end of the back side.
r—> (09) --->°dg/-,
Reverse Reverse
\--/09) + ---(O\47
*
The
reverse
recording/playback
mode
{
=
)
is
set
automatically
during
recording.
Check the following before recording or playing cassette tapes:
1. Is the head dirty? ... The sound quality will be poor if the head is dirty.
2. Are the accidental erasure
Res Prevention tabs broken Off? ou... Recording is not possible if they are.
NOTE:
© Be sure to load the cassette tape with the open side facing away from you. Loading it in the opposite direction can cause damage.
¢ Do not press the OPEN/CLOSE button during playback or recording. Always press the STOP button before pressing the OPEN/CLOSE button.
Using the Tape Counter
e Reset the counter toOQ00by pressing the COUNTER RESET button.
Auto Tape Selector Mechanism
This deck is equipped with an auto tape selector mechanism which uses the Accidental erasure prevention tabs Detection holes
detection holes in the cassette halves to automatically set the recording bias
and equalization best suited for that type of tape.
® Do not use ferrichrome tapes.
© Use meta! tapes equipped with detection holes.
Detection
Metal tape Chrome tape
11