Denon UDRA-70 - SYSTEM SETUP; Main Features Overview; Antenna Connections

ENGLISH
MAIN FEATURES
@ 30 FM/AM station random preset tuner .
* Random presetting makes for easy operation.
e Power amplifier designed for quality sound
* 30W + 30W high quality power amplifier.
e SDB control °
* Super dynamic bass control for clear low bass sound.
e Super linear converter and high performance digital filter °
* Denon’s unique systems for preventing loss of CD sound quality
create an excellent sound field. °
BEFORE USING
e Moving the system e
To prevent short-circuiting or damage of connection cords, be sure to
unplug the power cord and disconnect all connection cords before
moving the system. e
In addition, always remove CDs before moving the system. If not, the
CD may be scratched.
e Before turning the power on
Check again that all connections are proper and that the connection e
cords are not damaged. Always set the power switch to the STANDBY
position before disconnecting connection cords.
ANTENNA CONNECTIONS
Editing circuit. included
* When performing edited recording onto tapes, trakcs can be
selected automatically so that the blank space on the tape is
minimum.
Dolby B, C N.R
* For playback and recording with high quality sound.
CD SRS circuit
* CDs can be recorded at the touch of a button.
Easy-to-use remote control unit
Humming may be produced if the system is set near a TV set or other
audio component or its connection cords. If this happens, try changing
the position of the equipment and connection cords.
Do not move the system abruptly from a cold place to a warm place, as
this may cause dew (water droplets) to form in the set, preventing
proper operation. If this happens, wait one hour before using the
system.
Be sure to keep this manual.
The illustrations used in this manual may differ from the actual system.
FM OUTDOOR ANTENNA
Open the cover 7Sonm COAXIAL CABLE 300 ohm
ANTENNA
FM INDOOR ANTENNA
(an Accessory)
300 ohm
75 ohm COAXIAL CABLE
Attach to the holder
AM OUTDOOR
ANTENNA
75 ohm
ANTENNA
COAXIAL
CABLE
75 ohm COAXIAL CABLE
Assembling the Loop Antenna
e@ Remove the tie fastening the loop anten-
na’s lead and connect the lead to the
antenna terminals.