Denon UDRA-70 - CONNECTIONS; Connecting the System Connector Cord

Power plug
Connect the speaker system for
e
AM
loop
antenna
the
left
channet
(the
left
side
as
seen from the front) to the L
terminals, the speaker system for
the right channel to the R termin-
ais. Connect the speaker systems
before inserting the system con-
nector.
{Speaker impedance at 8 ohms.)
FM antenna
Refer to Page 4.
SNOILOANNOD
Record Player (Option)
the system connector wire to prevent noise
from entering the antennas.
Keep the FM and AM antenna wires away from |
(MM cartridge} Ground Wire
Super Woofer
(Option)
(Option)
(Left channel)
(Right channel)
Only connect the AUDIO jacks
when connecting a DAT.
VTR/DAT
Do not plug the power cord into the power outlet until all connections
are completed. Connect properly as shown in the diagram.
Check the right and left channels, and be sure to connect the
speaker's L terminals to the amplifier's L terminals, the speaker's R
terminals to the amplifier's R terminals.
@ Be sure to insert the plugs securely. Incomplete connections can
cause noise.
Note that grouping connection cords (pin-plug cords) together with
power cords or setting them near power transformers can cause
noise.
Note that if the input jacks selected with the FUNCTION selectors are
open {if nothing is connected), the sound may leak to another
component connected to different input jacks.
R
Connecting the System Connector Cord
The sets can also be placed
:
; ;
next
to
one
another.
When
connecting
the
system
connector
When
disconnecting
the
system
connec-
(Set
the
receiveron
the
very
top.)
cord,
press
on
the center
of
the connector
tor
cord, press
the
sides
of
the
connector
plug until you hear a ctick. plug towards the middle and pull. NOTE
This system includes
digital circuitry, so it
may cause problems
with the colors on a TV.
If so, turn the system‘s
power switch off.
Aide OO
2
Connector plug €
Connector cord ~
| Note that disconnecting by pulling on the cord can damage it. |
m
2
GQ)
a
2)
=.