Denon UDRA-90 - Writing Station Characters; Character Input Method; 7 USING THE TIMER; Setting the Timer and Current Time

The D-90 includes a function for writing characters.
Example:
Writing
the
characters
“MY
RADIO”
for
the
station
at
FM
107.70
MHz
and
storing
this
at
preset
channel
5
Use the BAND button and the AUTO TUNING UP
and DOWN buttons to display FM 107.70 MHz.
FM 107,10
sS Preset —
ea es
FM 107, 10~
Press the MEMO button for at least 3 seconds
so that “PRESET” flashes on the display.
—preser—
“IW
FM 107,10
Use the AUTO TUNING UP and DOWN buttons to
select preset channel 5,
Press the ENTER/NEXT button.
The "-”" begins to flash.
Use the AUTO TUNING UP and DOWN buttons to
select the character “M", then press the PRESET
UP button.
The “—" stops flashing, and the “M" in the second
place starts flashing.
Use the AUTO TUNING UP and DOWN buttons to
select the character “Y”, then press the PRESET
UP button.
Repeat this procedure to write “MY RADIO”, then
7 press the ENTER/EXIT button.
“PRESET” stops flashing and the character writing
mode is cancelled.
My RADIO
The characters which can be written are shown below.
© The characters change in the direction of the arrow when the PRESET UP button is pressd, in the opposite direction when
the PRESET DOWN button is pressed.
The character sequence starts over from A each time a character is set.
ABC DEFGHIYKLMNOPGRS TUYWKY £7
+ 12945674 CX J+-/2£4\_1 €-. SPACE
A aes eee
NOTES:
e The cursor can be moved to correct a character by pressing the PRESET button during the character wirting mode.
e If the frequency of the station for which characters have been written is the same as the frequency of a PS broadcasting
station, the characters are rewritten by the PS signal.
e Characters can also be written in the same way when in the AM mode.
USING THE TIMER
Setting the Timer
@
Be
sure
to
set
the
current
time.
;
;
e
Regular
timer:
The
power
can
be
switched
on
and
off
once
every
day
at
the
same
time.
(Wake-up
music}
;
@
Sleep
timer:
The
power
can
be
set
to
turn
off
in
up
to
60
minutes
in
steps
of
10
minutes
using
the
remote
control
unit.
(Bedtime
music)
Be sure to preset stations before setting the timer.
Refer to “Presetting FM and AM Stations” on Page 9.
e@ Turn the standby switch off when not using the timer.
Power Failure
Should
a
power
failure
occur
or
if
the
power
cord
becomes
unplugged
from
the
power
outlet,
”
00:00
“
will
flash
on
the
time
display.
If
this
happens,
reset
the
current
time.
{Reset
the
current
time
and
timer
settings.
If
“09:00
"
was
displayed,
also
reset
the
stations
preset
on
the
tuner.)
The
standby
mark
starts
flashing
if
there
is
a
power
failure
or
the
power
cord
is
unplugged
while
the
standby
mark
is
lit.
If
this
happens,
reset
the
time
and
the
timer.
(If
the
display
reads
“00:0C",
also
reset
the
tuner’s
preset
channels.)
To
make
the
standby
mark
stop
flashing,
press
the
TIMER
button,
then
press
the
TIMER
or
CLEAR
button
while
”
FUN”
is
displayed.
Setting the Current Time (A 24-hour clock display is used.)
Press the POWER button of
the receiver.
ON/STANDBY
G we
LY =LJz OU The hour's place flashes.
7TINS
DISPLAY ii
Depress the DISPLAY button
located in the trap door for 3
seconds or longer. (All places flash if the time has already been set.)
stile,
G yi Is
DOWN UP
AUTO TUNING
Set the hours with the UP
mM The set places flashes.
and DOWN buttons. u a
- ~
aa
Cy
Nob,
~
IOo0 LE The minutes’ places flashes.
Cary IE
Press the ENTER/NEXT button.
Nubhibe,
Qe = The set places flashes.
STATS
© &
DOWN UP
AUTO TUNING
Set the minutes with the UP
and DOWN buttons.
Press the ENTER/NEXT button
at the sound of a time signal.
The time display fights steadily
and the clock starts keeping
the time.
The display lights steadily
and the clock starts to
count from 0 seconds.