Denon UDRA-90 - Page 8

e This is displayed on the display of the receiver unit (UDRA-90).
This tights when the
memory stop function is
turned on.
CD PLAYER DISPLAY
@ This is displayed on the display of the receiver unit (UDRA-90).
Track number display
00 is displayed when the disc data cannot be read
properly.
When a disc is loaded:
e@ The total number of tracks is displayed in the stop
mode.
e The track number is displayed in the play and
program modes.
® (£01 3} is displayed when the innermost or out-
ermost section of the disc is reached in the manual
search mode.
Time display
00080 is displayed when the disc data cannot be read
properly.
When a disc is loaded:
e The elapsed playing time is displayed in the stop
mode.
e The elapsed time for the track currently playing is
displayed in the play and pause modes.
The elapsed time for the programmed tracks is
displayed in the program mode.
TAPE
DISC IN Ae ky i
Tape type and remaining time display
During the editing operation, C 90 lights and the tape time is
displayed.
PROGRAM lights during the programmed
selection mode.
This is the tape counter. Indicates the direction of tape travel.
7
1678 9101
1112131415!
it 17 18 19.20
121 22 23 2425!
R '
(26 27 28 29 30
@ The counter is reset to “D000” when the tape is ejected and loaded, and when the COUNTER RESET button is pressed.
@ Making a memo of the contents of a recording and the range of the counter numbers while you are recording or playback
back a tape will be convenient when you search for a portion of the tape you would like to listen to or when you search for
the next portion you would like to record.
During the editing operation, EDIT A TAPE lights up, the remaining This lights when
time for side A of the tape is indicated on the time section of the there are 31 or more
display, the track numbers set for side A light on the calendar section tracks on the disc.
of the display, while the track numbers set for side B flash. When the
TAPE A/B button is pressed, A goes off, B lights, and the remaining
time and track numbers set for side B are indicated in the same way.
» PLAY lights when the
disc is playing, and W
PAUSE lights when in the
Dolby noise reduction manufactured under license from Dolby Laboratories Licensing Corporation. pause mode.
“DOLBY” and the double-D symbol DX) are trademarks of Dolby Laboratories Licensing Corporation.
The indicators switch as follows when the REPEAT button is pressed in the play mode:
REPEAT 1: REPEAT 1 (single track repeat) The repeated track number lights on the music calendar.
REPEAT ALL: REPEAT ALL (all tracks repeat) The track numbers of the tracks on the disc light.
Third press: REPEAT A-
Fourth press: REPEAT A-B
Fifth press: No display
e When track 31 or higher is repeated in 1-track repeat, the TRACK number flashes.
Music calendar display
This indicates the track numbers on the disc to a maximum of 30.
The track numbers go off after the corresponding tracks are played.
In the program mode, the track numbers of the programmed tracks are indicated to a maximum of 30.
All track numbers from 4 to 30 light when the disc data cannot be read properly.
e NO DISC lights on the display if no disc is loaded, or if the disc is loaded upside-down or is heavily scratched or dirty.