Denon UDRA-90 - 6 LISTENING TO RADIO BROADCASTS; Tuning and Preset Stations; RDS and Auto Tuning Features

LISTENING TO RADIO BROADCASTS
(Check that connections are proper, referring to Pages 5)
PERSONAL COMPONENT SYSTEMATERIO RECEIVER UDRA-90
POWER
Set
the
VOLUME
control
to
the
—QN/STANDBY
minimum position, then press the
POWER button of the receiver.
Set to FM.
FM 90.00
Select the FM band with the
BAND button.
Lights up when the station is tuned in.
“FM 81,50=
Use the UP and DOWN buttons to
set the frequency to 87.50 MHz,
located in the trap door.
2 Sy
AUTO__TUNING
Press the MEMO button.
“PRESET” flashes for 10 seconds.
Use the AUTO TUNING UP and
DOWN buttons to call up the
number to which you want to preset © G
the station.
Or, directly press the number buttons
on the remote control unit.
The preset number will flash.
DOWN UP
AUTO TUNING
Press the MEMO button while @
“PRESET” is flashing.
the preset number 3.
Up to 30 FM and AM stations can be preset at random using this procedure.
Note: The character writing mode is set if the MEMO button is pressed in for over 3 seconds.
Auto Tuning
e@ When the TUNING buttons are pressed, the frequency changes in steps of 50 kHz for FM, 9 kHz for AM.
@ lf the TUNING UP or DOWN button is held in for more than 0.5 second, the frequency continues to change when the button
is released. The next station is tuned in automatically and the tuning stops there. The auto tuning might not stop when a
weak signal is received at the antenna. At this time the TUNED display will not light. To stop the auto tuning, press the UP or
DOWN button again.
Example: Listening to the FM station preset at number 3
Press the TUNER BAND button
on the remote control unit.
“EM 81,50~
Press button “3” on the remote
control unit.
FM Stereo Reception
e
When
the
MONO/ST
button
is
pressed
(which
tights
the
AUTO
indicators)
and
an
FM
stereo
broadcast
is
received,
the
STEREO
indicator
lights
and
the
station
is
received
in
stereo.
If
the
MONO
indicator
is
lit
by
pressing
the
MONO/ST
button,
the
STEREO
indicator
goes
off
and
the station
is
received
in
monaural.
Notes on Presetting
@
When
an
FM
station
is
preset,
the
auto
or
monaural
mode
is
also
set,
so
check
the
display
before
presetting
the
station.
¢ If a station is preset to a number at which another station has previously been preset, the previous station is cleared and the
new station is preset.
If the power cord is unplugged, the preset memory is not cleared immediately, but will be cleared if the cord is left
unplugged over a long period. Should this happen, preset the stations again.
Receiving RDS broadcasts (FM only)
Press the BAND button and set the FM band.
FM 8 1.50=
Press the RDS button once.
“RDS” blinks
Flashes
= RO’
FM 87.50~
Press the AUTO TUNING UP or DOWN button.
“RDS” blinks
“RDS” lights after 5 seconds of flashing.
The station is tuned in. Station name
Once the station is tuned in, “RDS” flashes for 5
seconds and the program service name is displayed.
When another station is desired, press the UP or DOWN
button of AUTO TUNING while “RDS” is flashing and
start the tuning.
NOTE: If no RDS station is found,” NO RIS ” is displayed.