-15-
used for mobile identification, either promptly alter the usage frequency, or halt the electromagnetic
discharge
3. If other problems arise due to reasons such as electromagnetic interference from this device to a specified
low-power wireless station being used for mobile identification, please contact DENSO WAVE through
QBdirect.
• Requests to system designers
1. Communication may not be possible depending on the environment in which the device is being used.
Ensure that problem-free communication is possible prior to use.
2. Use a program capable of retransmitting data if communication fails.
3. If the BHT is introduced into an environment in which a device using 2.4 GHz waveband electromagnetic
waves is operating, or if another device using 2.4 GHz waveband electromagnetic waves is introduced
following introduction of the system, run all devices and ensure that communication with the BHT is
possible prior to use.
4. Check communication once again prior to use if any changes are made to the usage environment (addition
of household appliances, movement or addition of shelves, equipment and so on) following introduction of
the system.
To Next Page
Loading...