DentistRx Intelisonic Sterling - Brushing Techniques and Time; Brushing Technique; Brushing Time; Sanitizing the Brush Heads

DentistRx InteliSonic Sterling 7
3. Wet the toothbrush bristles and place a small amount of toothpaste on the brush.
4. Place the bristles against the teeth at a 45-degree angle
towards the gum line to ensure the bristles are in close
contact with the space between teeth and gums.
5. Press the power button to turn on the toothbrush.
6. Apply light pressure and gently move the brush head
slowly across the teeth in a small back and forth motion.
Continue this motion throughout the brushing cycle.
BRUSHING TIME
1. In order to maximize cleaning effectiveness, divide your
mouth into 4 sections. Start with Section 1 and brush each
section for 30 seconds. The brushing action will pause
between each 30 second interval, indicating when to move
on to the next section. The toothbrush will automatically
stop after 2 minutes of use.
Note: If you change the cleaning mode during the brushing cycle, the 2
minute brushing timer will reset and start over.
2. After completing the brushing cycle, you can spend
additional time brushing the chewing surfaces of your
teeth and areas where staining occurs. You may also brush your tongue,
with the toothbrush turned on or off, as per your personal preference or
dentist recommendation.
Note: The InteliSonic is also safe to use on:
• Dental restorations (fillings, crowns, veneers)
• Braces (brush heads will wear out sooner)
ADDITIONAL ORAL CARE NEEDS
Periodontal pockets: Spend extra time working the bristles into the pockets
where plaque collects below the gumline. Ask your dental professional for help
with identifying these areas.
SANITIZING THE BRUSH HEAD(S)
1. Place the brush head bristles under running water and rinse after each use.
2. Gently shake the toothbrush to remove any excess water after cleaning.
3. Lift and open the travel case lid.
4. Place the brush head(s) in the UV sanitizer
travel case directly facing the UV light.
5. Make sure the travel case is plugged into a
working outlet.
6. Close the travel case lid to activate the UV
sanitizing process.
7. UV Sanitizer Indicator Light will illuminate
indicating the sanitizing cycle has started.
8. When the sanitizing cycle is complete, the
UV Sanitizer Indicator Light will automatically turn off and the lid will no
longer glow.
9. When using the UV sanitizer:
• Only insert InteliSonic Sterling heads into the sanitizer.
• The UV sanitizer will only work when the travel case lid is closed, the
charging cord is connected, and plugged in.
• The UV sanitizer will run for 7 minutes and shut off automatically.
• The sanitizer will not run unless plugged in.
• The UV sanitizer will run automatically every time the lid is closed.
30
SECONDS
1
30
SECONDS
3
30
SECONDS
4
30
SECONDS
2
45
°