DENTSPLY Miniglaze/2 User Manual

12 pages

To Next Page

Owner & Operator's Manual

Model No: Voltage:

9490950 115V 50/60Hz

9490952 220V 50/60Hz

DESCRIPTION PAGE

Safety...................................................................................................2

Features...............................................................................................3

Furnace Description............................................................................4

Installation............................................................................................5

Control Description..............................................................................6

Setup & Maintenance..........................................................................7

Operating Instructions.........................................................................8

Specifications.......................................................................................9

Trouble Shooting..................................................................................10

Accessories.........................................................................................11

Product Service...................................................................................11

Warranty..............................................................................................Back

Miniglaze/2

PORCELAIN STAINING AND GLAZING FURNACE

Questions and Answers:

N
njohnsonJul 31, 2025
How to troubleshoot a DENTSPLY Furnace when the muffle does not heat and no lights are illuminated?
- M
  marksanthonyJul 31, 2025
  If the muffle in your DENTSPLY Furnace isn't heating and no lights are on, start by checking the power supply to the unit's AC receptacle. If the power supply is OK, replace the fuse with a 1A fuse (P/N: 9320071). If the issue persists, the circuit board may not be functional and require replacement (P/N: R9494084 for 115V, or P/N: R9494085 for 230V).
C
cindy90Aug 14, 2025
What to do if the muffle does not heat in my DENTSPLY Miniglaze/2?
- N
  Nancy RobinsonAug 14, 2025
  If the muffle in your DENTSPLY Furnace isn't heating, it could be due to several reasons: * The thermocouple may not be tightened to the pyrometer - check the TC wires on the pyrometer. * The thermocouple may be burned out (open) - replace the thermocouple (P/N: 9490573). * The circuit board may not be functional - replace the circuit board (P/N: R9494084 for 115V, or P/N: R9494085 for 230V). * The muffle may be burned out - replace the muffle (P/N: 9490567 for 115V, or P/N: 9490585 for 230V). * The thermocouple may be shorted - replace the circuit board (P/N: R9494084 for 115V, or P/N: R9494085 for 230V). * There may be a wiring problem - return the unit to DENTSPLY Ceramco. In addition, calibrate the meter as per instructions.

DENTSPLY Miniglaze/2 Specifications

General

Brand	DENTSPLY
Model	Miniglaze/2
Category	Furnace
Language	English

DENTSPLY Miniglaze/2 User Manual

Table of Contents

Questions and Answers:

DENTSPLY Miniglaze/2 Specifications

Summary

Safety Information

OSHA and Proposition 65 Compliance

Product Features

Furnace Description

Installation Instructions

Unpacking the Furnace

Furnace Placement and Connection

Control Panel Overview

Temperature Indicator

Temperature Control Dial

Tone/Light Switch Function

Muffle Power Indicator Light

Temperature Rise Control Dial

Calibration Screw Adjustment

Setup and Maintenance Procedures

Furnace Calibration Process

Cleaning Guidelines

Operating Instructions

Staining and Glazing Procedure

Technical Specifications

Troubleshooting Guide

Available Accessories

Product Service and Support

Product Warranty Information