Denver CAP-4300 - Troubleshooting (Continued); Distorted Output (contd); Poor Bass Response; Battery Fuse Blowing

ENG-7
symptom
possible cause
action to take
manual
distorted output
(cont'd)
speakers are blown
check system with known
working speakers and repair or
replace as needed
poor bass
response
speakers wired wrong
polarity causing cancellation
at low frequencies
check speaker polarity and repair
as needed
crossover set incorrectly
reset crossovers referring to the
multi-cross crossover
configuration section of this
manual for detailed instructions
battery fuse
blowing
impedance load to amplifier
too low
check speaker impedance load,
if below 2Ω stereo or 4Ω mono
rewire speakers to achieve a
higher impedance
short in power wire or
incorrect power connections
check power and ground
connections and repair as
needed
fuse used is smaller than
recommended
replace with proper fuse size
too much current being
drawn
check speaker impedance load,
if below 2Ω stereo or 4Ω mono
rewire speakers to achieve a
higher impedance
short in power wire or
incorrect
check power and ground
connections and repair as
needed
amplifier fuse
blowing
too much current being
drawn
check speaker impedance load,
if below 2Ω stereo or 4Ω mono
rewire speakers to achieve a
higher impedance and replace
with recommended fuse size
check power and ground
connections and repair as
needed
fuse used is smaller than
recommended
replace with proper fuse size