Depot2U
Last update: 07/10/2021
HW
Upper Display Menu:
The upper display menu is responsible for showing you speed.
The default setting is current speed.
Long press the S+ button to change between current speed, max speed recorded and
average speed. When the bike is switched off, the values will reset to 0 for your next trip.
Lower Display Menu:
The lower display menu is responsible for showing you overall milage recorded on the bike
(odometer), current trip milage, current battery voltage, output current to motor and the
duration of time that the bike has been switched on for.
Short press the Power button to change between ODO (odometer), TRIP (current trip
milage), VOL (current battery voltage), CUR (N/A to this bike) and T1 (duration of time the
bike has been switched on for)
Walking assist:
Walking assist is useful for maintaining the bike at a walking speed without pedalling. Press
and hold CUR or S- to activate walking assist. Walking assist will only go to 3kph.
To disengage walking assist, press any of the brake levers.
Lights:
The rear light is always switched on to maintain visibility. Being an LED, this draws minimal
power from the battery and has little to no effect on the charge of the battery.
The front light is operated by pressing the CUR button once (short press) to switch on, and
another short press to switch off.
To Next Page
Loading...