DERMAPEN 4 - Step 4: Active Ingredients Application

18
19
6 - ORDER OF TREATMENT
Step 4 – Active ingredients application & treatment
1. Visually section the treatment area into six regions; i.e. forehead, chin, cheeks, eye area,
nose and lip area.
2. Apply a uniform layer of Dp Dermaceuticals Hyla Active™ on one treatment region
at a time. As miniscule puncture channels are created, these enable the infusion of
procedural mediums and ‘meso-glides’. *
3. Hold the Dermapen 4™ device in one hand, and gently hold the skin taut with the other
hand.
1
2
2
6
6
3
4
5
TM
First Pass: Start with stripe-like motions, from top to bottom,
lifting the needle tip between each stripe instead of a zig zag
motion to avoid unnecessary reinsertions. Oscillation or depth
may be adjusted mid-procedure. For optimal treatment, apply
the Dermapen 4™ to skin with light pressure only.
Second Pass: While exerting a constant pressure, treat from
side to side as shown left.
Third pass: While exerting a constant pressure, treat in a
diagonal direction as shown left.
Fourth pass: While exerting a constant pressure, treat in the
other diagonal direction as shown left.
It is not recommended to treat using circular motions. A ‘stamping’
e ect may be implemented when using the Scar Treatment (ST)
setting.
*For patient safety and optimal treatment outcomes it is recommended to ONLY use
Dp Dermaceuticals™ as a treatment glide.
HYLA ACTIVE IN ZONES & TREAT IN TX ZONES