To Next Page

To Previous Page

EX, SGX VIBRATOR MOTORS

01 May 09 19

SGX MOTOR BEARING REPLACEMENT KITS

Part Number Description Qty

Bearing Replacement Kit - G0003904

G0001696 Bolt, Jack, Hex Skt Hd, M8-1.25 x 70mm, Aly Stl 2

G0001960 Bearing, Vibrator 2

PP1503 O-Ring, 7.90 ID x .070 Cross Section, Viton 2

14266-01 Mount, Bearing, Vibrator, A4140 Stl 2

G0002250 Grease, Vibrator, SCH-100, 10-Oz. Tube 1

Bearing Replacement Kit With Tools - G0003905

G0001696 Bolt, Jack, Hex Skt Hd, M8-1.25 x 70mm, Aly Stl 2

G0001960 Bearing, Vibrator 2

PP1503 O-Ring, 7.90 ID x .070 Cross Section, Viton 2

14266-01 Mount, Bearing, Vibrator, A4140 Stl 2

G0001698 Torque Wrench, 3/8” Drive, 150 to 750 In Lb 1

G0008935 Driver, Hex, 6mm Male, 6.063 L X 3/8” Drive 1

G0001700 Wrench, Hex, T-Handle, 5mm Alloy Stl 1

G0003126 Wrench, Ratchet, 3/8” Drive, Ind. Finish 1

G0008317 Socket, Allen Bit, 5mm Lg, 3/8” Drive 1

G0002250 Grease, Vibrator, SCH-100, 10-Oz. Tube 1

Tools Required

Following is a recommended tool list for use during the bearing replacement procedure:

 Torque wrench (200 to 1000 in lbs)

 Hex wrench (5mm)

 Hex wrench (6mm)

 Dental pick or similar tool

 Clean, absorbent cloths

 Safety glasses

 Heat-resistant gloves (250° F or higher)

 Welder’s torch

 Bearing heater

Work Area Environment

A well-lighted area with sufficiently large work-surface area is required to work on the motor. The

work surface should be clean to prevent contamination of the new bearings and motor interior.

DERRICK EX User Manual

Questions and Answers: