Desa Ga3750a - User Manual

To Next Page

Parts included with this kit:

Part No. Description Quantity

Blower with speed control and 6-foot cord. 1

Instruction Sheet 1

103650-01 Control Knob 1

103651-01 Lock Nut 1

M11084-38 #8 x 3/8" sheet metal screws 5

101629-01 Plastic Hole Bushings 2

101584-05 Wiring Diagram Decal 1

Tools Required

• Pliers

• Phillips Screwdriver

If any of these pieces are missing or damaged, or if the installation instructions for your fireplace or stove are not included in this manual,

contact the dealer where you purchased this kit or DESA at 1-866-672-6040 for referral information.

(Check your appliance owner’s manual for specific applications and additional instructions.)

WARNING: ELECTRICAL GROUNDING INSTRUCTIONS This appliance is equipped with a three-prong

(grounding) plug for your protection against shock hazard and should be plugged directly into a properly

grounded three-prong receptacle.

For Use With:

Fireboxes: (NL)FB32C, (NL)FB36C, FB42C, (NL)UV32C, CGFB32C, and CGFB36C Series

Vent-Free Fireplaces: VSGF28, VYGF33, VTGF33, VCGF30, VSGF33, FPV33, CGFP28, LFP33 Series,

and (CG)EFP33 Series

Direct-Vent Fireplaces: (E)BDV, BHDV, DVF(E)34, DVFH34, CDV, and CHDV Series

Stoves: CSDBN, SDVB, MSDVB MSTD, CDV, S39T, and S26T Series

INSTALLATION INSTRUCTIONS

GA3750A BLOWER ACCESSORY

For more information, visit www.desatech.com

Save this manual for future reference.

Need help?

Do you have a question about the Desa Ga3750a and is the answer not in the manual?

Summary

Installing Blower Accessory in a 32 Firebox

Connect Blower Power Cord

Plugging the blower power cord into a grounded electrical outlet.

Installing Blower Accessory in 36 or 42 Firebox

Remove Firebrick and Side Panels

Remove Firebox Bottom Assembly

Perform Final Checks and Reassembly

Installing Blower Accessory in SVFBC Freestanding Stove

Remove Mounting Bracket and Plug Button

Attach Blower to Mounting Bracket

Securing the blower assembly to the stove's mounting bracket.

Installing Blower Accessory in 32 Fireplace Systems

Prepare Fireplace and Remove Components

Connect Blower Motor and Ground Wire

Attaching power cord terminals and ground wire to the blower motor.

Installing Blower Accessory in Freestanding Stove Series SDV, MSD, MSTD, CDV or CSDBN

Remove Rear and Bottom Covers

Mount Blower and Attach Power Cord

Securing the blower and connecting the power cord and ground wire.

Installing Blower Accessory in Direct-Vent Fireplace Series

Prepare Firebox and Attach Power Cord

Mount Blower Unit to Firebox

Securing the blower assembly to the lower rear wall of the direct-vent firebox.

Install Speed Control and Knob

Mounting speed control and knob to the switch plate on the firebox.

Connect Power Cord and Bushings

Perform Final Checks and Apply Decal