6
4. SMART LOCK SETTINGS
IMPORTANT NOTE: You can change the settings through keypad if
it is paired as master controller to smart lock.
4.1. Pairing Wireless Controllers to the Smart Lock
- Tap with your palm to wake up the device. Then touch the
“SETTINGS” button. "MASTER" will be displayed on the screen.
- Enter 5 digit master password. “≡≡” symbol will appear on the
screen.
- Touch the "6" button. "U.ENROLL" will appear on the screen.
Touch the "SETTINGS" to start pairing.
- A long tone will be heard first, then a short tone. Send an RF
signal from the device you want to pair with after the short tone.
(Please refer to the next page to send RF signal from controllers)
The new controller will be paired to the smart lock when 2 sequential
warning tones are heard.
To Next Page
Loading...