Design Within Reach MIN

To Next Page

ASSEMBLY INSTRUCTIONS

MIN UPHOLSTERED HEADBOARD

design Luciano Bertoncini

“A” x 1

headboard

“B” x 2

upper bracket

NOTICE

Product intended to be assembled by an adult due to the presence of small parts.

Screws must be tightened and fully inserted into the frame. To achieve this we recommend holding the longer side of the hexa-

gonal key supplied and apply pressure.

USE AND MAINTENANCE

Clean metal parts of the product using a soft cloth moistened with a solution of water and mild soap; wipe dry immediately

using a soft dry cloth. Furniture cleaning products may also be used.

The colour of parts may change with exposure to direct sunlight. Do not use acids, solvents or abrasive products.

Fabric parts are removable, maintenance information on the care label.

(composition 100% PL-FR)CARE LABEL “OXY-FR” FABRIC

“C” x 2

under bracket

“E” x 2

washers

“D” x 2

M8x20 hexagon head screw

“F” x 1

hexagonal key

light washing

temperature

40° MAX

dry clean

do not

bleach

do not

tumbler dry

iron with

low temperature

To remove the fabric cover, turn the headboard over and lift and pull velcro straps.

Need help?

Do you have a question about the Design Within Reach MIN and is the answer not in the manual?

Summary

Min Upholstered Headboard Assembly Guide

Product Components Identification

Lists all parts and hardware required for headboard assembly, including headboard, brackets, screws, and key.

Important Assembly Notice

Warning about adult assembly due to small parts and recommended tightening technique for screws.

Usage and Maintenance Instructions

Guidance on cleaning metal parts, fabric care, and avoiding discoloration from sunlight.

Fabric Care Label Details

Information on washing temperatures, dry cleaning, bleaching, and ironing for the OXY-FR fabric.

Step 1: Align and Attach Upper Brackets

Instructions to center and position upper brackets on the frame, aligning supports for the headboard.

Step 2: Install Under Brackets and Screws

Guide to inserting under brackets with washers and screws, advising not to tighten completely.

Step 3: Position and Secure Headboard

Procedure to place the headboard and fully tighten all screws using the provided hexagonal key.