95-86261.2
BULB REPLACEMENT
WARNING
Always allow the test lamp to cool before replacing
the bulb.
When replacing the bulb, use only part number
103853-001, available from Detector Electronics. Use of
other bulbs can adversely affect the performance of the
test lamp.
1. Disconnect any power cords attached to the test
lamp.
2. Pull the rubber cover off the front of the test lamp.
See Figure 6.
3. Remove the Phillips screws from the reflector cap.
4. Remove the reflector. Use care not to damage the
wiring or connections.
CAUTION
Do not touch the glass bulb or the inside of
the reflector. Perspiration and oil from fingers
can adversely affect the performance of the
bulb. Handle the bulb by its metal base only. If
necessary, the bulb can be cleaned with alcohol.
5. Open the bulb retainer to release the bulb. (Push
the wire prongs together and pull up to release
bulb.) See Figure 7.
IMPORTANT
Note the location of each of the three bulb wires.
The wires must be connected to the new bulb in
the same way to ensure proper operation of the
lamp switches.
6. Disconnect the bulb wire connections from the old
bulb and install them on the new bulb.
7. Holding the new bulb by its base, install it in the
reflector.
8. Replace the wire bulb retainer.
9. Place the reflector inside the lamp housing.
10. Secure the reflector cap to the lamp housing using
the screws that were removed earlier. Use care not
to over-tighten.
11. Re-install the rubber cover.
ORDERING INFORMATION
When ordering, specify:
Description Number
Model W8067S1003 Test Lamp 006439-004
Model W1212 Portable Battery Pack 006438-001
Optional 220 vac ac/dc adapter (Euro) 103852-001
Bulb 103853-001
Internal Battery, 6V
(2 required for 12V Operation)
103855-001
Detector Electronics Corporation
6901 West 110th Street • Minneapolis, Minnesota 55438 • Operator (952) 941-5665 or (800) 765-FIRE
Customer Service (952) 946-6491 • Fax (952) 829-8750 • www.det-tronics.com • E-mail: detronics@detronics.com
RUBBER COVER
PHILLIPS SCREW (4)
REFLECTOR CAP
REFLECTOR
B2420
Figure 6—Front of Test Lamp with Rubber Cover Removed
BULB RETAINER
BULB
BACK OF REFLECTOR
BULB WIRES (3)
A2421
Figure 7—Bulb Removal
To Previous Page
Loading...