Compact Digital Multimeter CAT II 300V
Compact Digital Multimeter CAT II 300V
• Compact pocket digital Multimeter
• Suitable for carrying out basic AC/DC electrical measurements
• 3.5 digits (1999 count) LCD screen
• Sampling speed of 2 measurements per second
• Low battery indication
• Integral test leads clips on to the side of meter housing
• Overload protection
• Powered by 12V battery (included)
1. These instructions should be read carefully and retained for future reference.
2. Do not use the Meter if it is damaged or the case (or part of the case) is removed. Look for any cracks or missing plastic. Pay attention
to the insulation around the connectors.
3. Inspect the test leads for damaged insulation and exposed conductors.
4. Check the test leads for continuity.
5. Do not measure voltages exceeding the ratings marked on the Meter and between the terminals.
6. To prevent damage to the meter, do not change the rotary switch settings/range during measurements.
7. When using the test leads, keep fingers behind the finger guard.
8. Take extra precaution when measuring voltages above 60V DC or 30V rms AC.
9. Do not store the Meter in an environment with high humidity and temperature, and in areas with strong magnetic fields.
10. This product is suitable for indoor use only. Do not use in damp or wet conditions.
11. When not in use, store in a dry and secure place. Battery powered tools must not be stored in locations where the ambient
temperature may increase above 40°C.
12. Replace the battery as soon as the battery indicator appears. With a low battery, the Meter may produce false readings that can lead
to electric shock and personal injury.
13. Turn the meter off when not in use. If the meter is to be left unused for a long time, remove the battery.
Environmental Instructions
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic
equipment and batteries should never be disposed of with general household waste but must be separated for its correct treatment and
recovery. Where possible recycle your packaging.
Appearance of the battery symbol on the LCD display
indicates low battery. Replace the battery as soon as the low
battery indicator appears.
Before replacing the battery, make sure lest leads are disconnected
from any circuit under test.
Follow the steps below to replace the battery.
1. Turn the rotary switch to OFF position
2. To remove the battery cover, unscrew the two screws at the
rear of the device.
3. Remove the old battery and replace with a new one.
4. Screw in place the battery compartment cover.
To Next Page
Need help?
General
