Digital Multimeter CATIII 600V
Digital Multimeter CAT III 600V
• High performance, full featured digital Multimeter
• Suitable for wide range of AC/DC electrical measurements
• 4-digit (999 count) LCD screen, true RMS
• Low battery indication
• Non-Contact Voltage (NCV) detection function
• Battery voltage measurement
• Integral LED flashlight
• Overload protection and fuse disconnection
• Powered by 2 x 1.5V AAA batteries (included)
1. These instructions should be read carefully and retained for future reference.
2. Do not use the Meter if it is damaged or the case (or part of the case) is removed. Look for any cracks or missing plastic. Pay attention
to the insulation around the connectors.
3. Inspect the test leads for damaged insulation and exposed conductors. Check the test leads for continuity.
4. Do not measure voltages exceeding the ratings marked on the Meter and between the terminals.
5. To prevent damage to the meter, do not change the rotary switch settings/range during measurements.
6. When using the test leads, keep fingers behind the finger guard.
7. Take extra precaution when measuring voltages above 60V DC or 30V rms AC.
8. Do not store the Meter in an environment with high humidity and temperature, and in areas with strong magnetic fields.
9. This product is suitable for indoor use only. Do not use in damp or wet conditions.
10. When not in use, store in a dry and secure place. Battery powered tools must not be stored in locations where the ambient
temperature may increase above 40°C.
11. Replace the battery as soon as the battery indicator appears. With a low battery, the Meter may produce false readings that can lead
to electric shock and personal injury.
12. Turn the meter off when not in use. Remove the battery before leaving the meter unused for long time.
Environmental Instructions
This product may contain substances that can be hazardous to the environment if not disposed of properly. Electrical and electronic
equipment and batteries should never be disposed of with general household waste but must be separated for its correct treatment and
recovery. Where possible recycle your packaging.
1. Non-Contact Voltage (NVC), continuity and Live wire indicator
2. LCD Display
3. Function selection and variable-frequency voltage
measurement button
4. Range selection button
5. Frequency switching and flashlight control button
6. Data hold and LCD backlight control button
7. Function range selection rotary switch
8. V/Q/mA/µA/Cap/Battery/Live input terminal
9. 10A input terminal
10. COM input terminal
Warning, check the
manual for relevant
instructions
To Next Page
Need help?
General
