Need help?Do you have a question about the DETAIL K2 MMT5X7G-DUG and is the answer not in the manual?
General| Brand | DETAIL K2 |
|---|---|
| Model | MMT5X7G-DUG |
| Category | Utility Vehicle |
| Language | English |
Instructions for opening and unpacking trailer components, emphasizing ample workspace.
Place springs and tongue tubes with the hub end facing the front of the trailer.
Use M12 x 115 mm bolts at the front and M12 x 90 mm bolts at the back, inserted from inside out.
Mount the coupler and safety chains using M12 x 75 mm bolts and M12 lock nuts.
Lay the axle across the springs, ensuring the raised point on the spring fits the axle's concave.
Flip the trailer over, requiring assistance due to its estimated weight of 400 lbs.
Mandatory step to torque wheel nuts to 80 lb.
Connect trailer to vehicle and verify all lights are functioning correctly.
Inspect all completed steps and recheck all nuts for proper tightness before use.
Check all components thoroughly before each use for trailer longevity and safety.
Keep children away, never sit on the trailer, and use caution when tilting the trailer.
Distribute weight evenly over the axle, keeping about 10% on the tongue for stability.
Caution against building trailer load higher than 3' due to increased wind resistance and handling issues.
Understanding GVWR is crucial; trailer weight plus payload must not exceed this rating.
The tongue weight should be 10% of the load for proper trailer handling and stability.
To Next Page
