© Radionics Inc. reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to third parties.
35
Feature 1
Feature 2
Feature 3
The DS7400Xi is shipped from the factory as a working, pre-programmed
control.
Many of the programming addresses may already be set to the values you
need.
The default values are shown in
Reverse Print
Reverse Print
DS7400Xi Panel Wiring & Programming
Programming From the Keypad
0
Defaults
1 2 3 4 5 6
In the example above, a is the default value.
If the default value is not shown in , it will be shown in a
separate table.
To Next Page
