© Radionics Inc. reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying and passing on to third parties.
36
Feature 1
Feature 2
Feature 3
DS7400Xi Panel Wiring & Programming
Programming From the Keypad
Setting the Control to the Factory Default
Entering [0] [1] [#] in Program Address 4058 will immediately reset the
control to the factory default.
Any programming already done by the installer will be erased.
This action cannot be reversed.
Only enter [0] [1] [#] in Program Address 4058 when you are completely sure
you want to erase all installer programming.
To set the control’s programming values back to the default, enter the
programming mode, then enter [4] [0] [5] [8] [0] [1] [#].
1 2 3 4 5 6
To Next Page
