Need help?Do you have a question about the Dettson R02P029 and is the answer not in the manual?
Thermostat installation and control system components must conform to Class II circuits per NEC/CEC.
Each communicating device requires a consistent four-wire connection (R, C, 1, 2).
Verify proper operation of fan, heating, and cooling systems.
Verify fan operation by setting fan to Auto or On via the Run Schedule menu.
Verify cooling system operation by setting system to Cool and adjusting temperature.
Select system mode: Cool, Off, Heat, Emergency Heat, or Auto Changeover.
Select thermostat operating mode and adjust setpoint temperature.
Bypass program schedule to hold temperature indefinitely at a setpoint.
Allows thermostat to automatically switch between Heat and Cool modes.
Select fan operation: Auto runs fan with system; On runs fan continuously.
Check system status for faults or communication errors with equipment.
How to access and navigate the advanced installer configuration and service menus.
View fault status of connected equipment, including error codes and descriptions.
Access detailed information and settings for each connected piece of equipment.
Review logged fault codes, fault occurrences, and clear existing faults.
Review logged fault codes, fault occurrences, and clear existing faults.
Review logged fault codes, fault occurrences, and clear existing faults.
Review logged fault codes, fault occurrences, and clear existing faults.
General| Voltage | 24V |
|---|---|
| Programmability | 7-Day Programmable |
| Power Method | Hardwired |
| Type | Digital |
| Display | LCD |
| Programmable | Yes |
| Compatibility | Heat Pump |
To Next Page
