dS28
dS28
32
32 User Manual v4.10
Connecting I/O to Relays
Any of the eight digital I/O lines may be connected to a relay. This gives the digital output the
same automation capabilities as the relays. Enter the relay number in the link box as shown
above. Any relay may be selected for an I/O.
When you have configured the I/O, wait for the “Update Pending” light to go out and press the
reset button, as new I/O modes are set on power-up.
Copyright © 2016-2022, Devantech Ltd.
All rights reserved.
www.robot-electronics.co.uk
21
To Next Page
Loading...