6- ENG
D24152
Operation
Before each use:
l
Drain water from air compressor tank and condensation from air lines. See
air compressor’s operators manual.
Disconnect the tool from the
air supply before lubricating
or changing sockets.
l
Lubricate tool, see
“Maintenance” section in this
manual.
Impact
wrench
sockets and accessories
must be used with this tool.
Do not use hand sockets and
accessories.
l
Select the required impact
socket. This tool has a 1/2"
square drive, use 1/2” deep sockets. Use 1/2” extensions only when
needed.
l
Connect tool to air hose of recommended size. NOTE: The use of a quick
connect set makes connecting easier.
IMPORTANT: The use of air filters and air line lubricators is
recommended.
To use:
l
Turn air compressor on and allow air tank to fill.
ASSEMBLY
OPERATION
Air Inlet
Trigger
1/2”
Square
Drive
Accessories Required
IMPORTANT: Line pressure or hose inside diameter should be increased to
compensate for unusually long air hoses (over 25 feet). Minimum hose diameter
should be 3/8” I.D. and fittings should have 1/4” NPT thread.
Forward/
Reverse
Lever
Torque
Adjustment
SPECIFICATIONS
Maximum Torque 230 ft./lbs
Free Speed @ 90 PSI 7,000 RPM
Maximum Working Pressure 90 PSI
Air Inlet 1/4” NPT
Recommended Hose Size 3/8” I.D.
1/2” Impact Wremch
To Next Page
Loading...