are loose.
- Do not use the power cord if the cores are visible. Contact your dealer for a replacement if needed.
- Avoid the buildup of dust and dirt. Clean the exterior of the fixture every month with a dry or damp cloth.
When using the device intensively, the cleaning frequency needs to be increased. Disconnect the fixture
when it is going to be serviced.
- Do not cover the ventilation slots and/or heatsinks of this device with objects such as cloths which prevents
the device from cooling if needed.
- The mixing panel of this device can not be installed into a flat or fixed surface such as a desk or shelf.
Fuses:
- The main fuse of this device is to be found on the side of the mixing panel, next to the power inlet.
- Only replace a fuse for a new one with the same type and rating! Do not use a fuse with a higher or lower
rating.
- Do not bridge the fuse in any way, as the fuse is used for protection against electrical shocks and short
circuit. The fuse is a safety measure to protect you and your audience from hazardous electrical shocks.
- Always mount the fuse cover back to the fuse compartment. Do not use tape or other fastening materials to
close the cover. If the fuse holder is broken, contact your local dealer and do not use the fixture.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 2.0 Creation date + author initials: 29-09-2015 RV Revision date + author initials: 18-02-2017 RV
To Next Page
Loading...
