8. DECOMMISSIONING
8.1. STORAGE
8.2. DISPOSAL
1. Unplug the unit and remove exhaust hose and window kit store
with the unit.
2. Drain the remaining water from the unit.
3. Clean the filter and let the filter dry completely in a shaded area.
4. Re-install the filter at its position.
5. The unit must be kept in upright position when in storage.
6. Preserving the machine in ventilating, dry, non- corrosive gas and
safe place indoor.
ATTENTION:
The evaporator inside the machine has to be dried out before the
unit is packed to avoid component damage and molds. Unplug the
unit and place it in a dry open area for days to dry it out. Another
way to dry the unit is turn on the machine, adjust it to low-wind
ventilation mode, and maintain this state until the drainage pipe
becomes dry, so as to keep the inside of the body in a dry state and
prevent it from mildewing.
To Next Page
Loading...
