Cord: Inspect the power supply cord and plug, and all other parts of the appliance, for visual
damage. Do not use the appliance if anything appears to be damaged or not working properly. The
cord is 1.5m in length.
In case of damage, contact the Devola after-sales customer support team.
Documentation: Make sure you have read and understood all instructions and warnings in this
manual. Refer to the Product Overview to familiarize yourself with the product
and identify all parts. Pay particular attention to the safety instructions on the previous pages.
Remote control: The heater comes with a remote control powered by a 3V CR2032 battery.
Please refer to the instructions in the Other Useful information section for support on how to
replace the battery.
Plug: The DVSH20B and DVSH20WH models have UK 3 pin BS plugs. The DVSH20BE and
DVSH20WHE models have Euro two pole plugs.
Wall-mounting
IMPORTANT!
Only mount this heater on a structurally sound, heat-resistant wall area that is strong enough
to hold the weight of the heater. If in doubt, consult a builder. Do not mount this heater on
the ceiling!
The supplied installation hardware (and the instructions below) are for wall-mounting the
heater onto a masonry wall. Please obtain expert advice if you intend to wall-mount the
appliance onto any other type of wall.
Make sure to maintain the following minimum clearances when wall-mounting the heater:
10cm above the floor and 0.5 m below the ceiling.
Do not connect the appliance to the mains power supply until completely assembled,
installed, and adjusted.
Do not installed in a bathroom, Ensure the heater away from wet space or water.
To Next Page
Loading...
