18
ENGLISH
An exposure of the eye to the beam of a class 2 laser
is considered safe for a maximum of 0.25 seconds.
Eyelid refl exes will normally provide adequate
protection. At distances over 1 m, the laser complies
with class 1 and thus is considered completely safe.
• Never look into the laser beam directly and
intentionally.
• Do not set up the tool at a position where the
laser beam can cross any person at head height.
Residual Risks
• The following risks are inherent to the use of
these machines:
– Injuries caused by staring into laser beam.
Labels on attachment
The following pictographs are shown on the
attachment:
Read instruction manual before use.
Laser warning.
Safety warning: class 2 laser.
DATE CODE POSITION (FIG. A)
The Date Code (23), which also includes the year of
manufacture, is printed into the housing.
Example:
2010 XX XX
Year of Manufacture
Package contents
The package contains:
1 Laser
1 Switch box
1 Laser window
1 Hex key 2.5 mm
4 M4 x 10 crosshead screws
2 M3 x 12 hexhead screws
1 Instruction manual
• Take the time to thoroughly read and understand
this manual prior to operation.
Description (fi g. A)
1 On/off switch
2 Switch box
3 Laser head
4 Hex key
5 Laser window
INTENDED USE
Your D271059 laser has been designed to be
mounted to DEWALT D27105 and D27107. The laser
projects laser lines to extend the capabilities of your
DEWALT Flipover saws.
DO NOT use under wet conditions or in presence of
flammable liquids or gases.
These lasers are professional power tools.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
Unpacking
FITTING THE WARNING LABEL
The safety warnings on the label shown on the laser
must be formulated in the language of the user.
For that purpose, a separate sheet of self-adhesive
labels has been supplied with the tool.
WARNING: Check that the safety
warnings on the label have been
formulated in your language.
The warnings should read as follows:
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS 2 LASER PRODUCT
• If the warnings are in a foreign language,
proceed as follows:
– Remove the required label from the sheet.
– Carefully place the label over the existing label.
– Press the label in place.
ASSEMBLY AND ADJUSTMENTS
WARNING: Do not mount this
attachment to any other machine than
the DEWALT D27105 and D27107
flipover saw. Also refer to the instruction
manual of your power tool.
To Next Page
Loading...
