9
English
Hot/Cold Pack Delay
When the charger detects a battery pack that is too hot or too cold, it automatically
starts a Hot/Cold Pack Delay, suspending charging until the battery pack has reached an
appropriate temperature. The charger then automatically switches to the pack charging
mode. This feature ensures maximum battery packlife.
A cold battery pack will charge at a slower rate than a warm batterypack.
Electronic Protection System
XR Li‑Ion tools are designed with an Electronic Protection System that will protect the
battery pack against overloading, overheating or deepdischarge.
The tool will automatically turn off if the Electronic Protection System engages. If this
occurs, place the lithium‑ion battery pack on the charger until it is fullycharged.
Wall Mounting
These chargers are designed to be wall mountable or to sit upright on a table or work
surface. If wall mounting, locate the charger within reach of an electrical outlet, and away
from a corner or other obstructions which may impede air flow. Use the back of the charger
as a template for the location of the mounting screws on the wall. Mount the charger
securely using drywall screws (purchased separately) at least 25.4mm long with a screw
head diameter of 7–9mm, screwed into wood to an optimal depth leaving approximately
5.5mm of the screw exposed. Align the slots on the back of the charger with the exposed
screws and fully engage them in theslots.
MAINTENANCE
Your power tool has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper tool care and
regularcleaning.
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect battery pack before making any adjustments or removing/
installing attachments or accessories. An accidental start‑up can causeinjury.
The charger and battery pack are notserviceable.
C
Lubrication
Your power tool requires no additionallubrication.
To Next Page