DeWalt DCCS623 - Troubleshooting; Common Pruner Issues and Solutions

ENGLISH
16
DCCS623 TROUBLESHOOTING
BE SURE TO FOLLOW SAFETY RULES AND INSTRUCTIONS
For assistance with your product, visit our website
at www.dewalt.com for a list of service centers,
orcall
DeWALT at 1‑800‑4‑DeWALT (1‑800‑433‑9258).
Problem Solution
Unit will notstart. • Check batteryinstallation.
• Check battery
chargingrequirements.
• Check that lock off is fully
pushed down prior to moving
maintrigger.
Unit shuts down
inuse.
• Chargebattery.
• Unit is being forced. Restart and
apply lesspressure.
Battery will
notcharge.
• Insert battery into charger until red
charging light illuminates.
• Plug charger into a working outlet.
Refer to Important Charging
Notes for moredetails.
• Check current at receptacle by
plugging anappliance.
• Check to see if receptacle is
connected to a light switch which
turns power off when you turn out
thelights.
• Move charger and appliance to
a surrounding air temperature
of above 40°F (4.5°C) or below
104°F (+40 °C).
Bar / Chain
overheated.
• Refer to Adjusting Chain
Tensionsection.
• Refer to Chain Oiling section.
Chain isloose. • Refer to Adjusting Chain
Tensionsection.
Poor cutquality. • Refer to Adjusting Chain
Tension section. NOTE: Excessive
tension leads to excessive wear
and reduction in life of bar and
chain. Lubricate before each
cut. Refer to
Replacing the
Saw Chain and Saw Chain
Sharpening section.
Unit runs but does
notcut.
• Chain could be installed
backwards. Refer to sections for
installing and removingchain.
Unit does notoil. • Refill oilreservoir.
• Clean guide bar, sprocket
and sprocket cover. Refer to
Maintenancesection.