• Turn off power to heated jacket immediately if any
discomfort occurs.
• Do not allow cord to get tangled in zipper. Before wearing
heated jacket ensure electrical wiring is not damaged or
pinched. Do not use if cord is damaged. Fire may result.
• Do not attach pins or any other object to the heated jacket.
Doing so may damage the electrical wiring.
• If heated jacket does not operate properly discontinue use
immediately.
• DO NOT dry clean. DO NOT use bleach. Cleaning solvents
may damage or lessen the effect of the jacket's insulated
heating element.
• Follow the CARE label in the jacket and the instructions
under the Cleaning section of this manual.
• ONLY plug the heated jacket into the 12 V power jack on the
DCB091 USB power source.
• Ensure the battery/power source pocket is zippered shut when
wearing the heated jacket in rain or in wet conditions. The zippered
battery/power source pocket protects the battery pack and the
DCB091 USB power source from getting wet, which could result
in fire or other personal injury.
DCB091 USB Power Source Safety
Warnings
WARNING: This manual contains important safety and operating
instructions for this DCB091 USB power source. Before using the
DCB091 USB power source, read this manual and all labels on the
DCB091 USB power source, battery pack, charger and product(s)
using the power source.
• Shock hazard. Do not allow any liquid to get inside the DCB091
USB power source. Electric shock may result.
• Burn hazard. To reduce the risk of injury, use only DEWALT 12V
Max* and 20V Max* lithium ion battery packs with the DCB091
USB power source. Do not attempt to use it on any other battery
packs. Other types of batteries may overheat and burst resulting
in personal injury and property damage.
• This DCB091 USB power source is not intended for any
uses other than supplying power/charging small USB
electronics. Any other uses may result in risk of fire, electric
shock or electrocution.
• Do not operate the DCB091 USB power source if it
has received a sharp blow, been dropped or otherwise
damaged in any way. Take it to an authorized service center.
• Do not disassemble the DCB091 USB power source, there
are no user serviceable parts.
• The label on your product may include the following symbols. The
symbols and their definitions are as follows:
V ......................volts A .................. amperes
Hz ....................hertz W ................. watts
or AC ..........alternating or DC ..direct current
or AC/DC ...alternating .................safety alert
........................or direct current ..................symbol
.....USB connection
Important Safety Instructions for All
Battery Packs
When ordering replacement battery packs, be sure to include the
catalog number and voltage. Consult the chart at the end of this
manual for compatibility of chargers and battery packs.
English
2
To Next Page
Loading...
Need help?
General
