English
14
Inserting and Removing the Battery Pack
from the Tool (fig. 3)
NOTE: Make sure your battery pack (b) is fully charged.
TO INSTALL THE BATTERY PACK INTO THE TOOL HANDLE
1. Align the battery pack with the rails inside the handle.
2. Slide it firmly into place until you hear the lock snap into place.
TO REMOVE THE BATTERY PACK FROM THE TOOL
1. Press the release button (c) and firmly pull the battery pack out of
the tool handle.
2. Insert battery pack into the charger as described in the charger
section of this manual.
OPERATION
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
Switch (fig. 1)
To turn the light on, press the switch (a). To turn it off, press the switch
again.
Battery Indicator
As the battery nears a fully discharged state, the flashlight will blink
twice and then the brightness of the light will drop below the normal
level. This cycle will repeat for a period of up to 15 minutes until the
battery is fully discharged.
To Next Page
Loading...
