15
indicator light will flash to let you know the battery
is being charged.
4.
After the battery is fully-charged (the indicator light
on the charger no longer flashes), press and hold
the release button on the battery pack (Figure
A
2
) and slide the pack out of the charger
(Figure
A
3
).
5.
Slide the battery pack down in the laser until it
snaps in place (Figure
A
4
).
Viewing the Battery Meter
When the laser is ON, the battery meter on the keypad
(Figure
C
7
) indicates how much power remains.
• The bottom LED will illuminate and ash when the
battery level is low (10%). The laser may continue
to operate for a short time while the battery power
continues to drain, but the beam(s) will quickly dim.
• After the 12V/20V MAX Li-ion battery is charged, and
the laser is turned ON again, the laser beam(s) will
return to full brightness and the battery indicator level
will indicate full capacity.
• If all 4 LEDs on the battery meter remain ON, this
indicates that the laser is not fully powered OFF.
When the laser is not in use, make sure the Power/
Transport Lock switch is placed to the LEFT to the
Locked/OFF position (Figure
C
2
).
Operating Tips
• To extend battery life per charge, turn the laser off
when it is not in use.
• To ensure the accuracy of your work, check the
laser calibration often. Refer to Checking Laser
Accuracy.
• Before attempting to use the laser, make sure it is
positioned securely, on a smooth, at stable surface
that is level in both directions.
• To increase beam visibility, use a Laser Target Card
(Figure
M
) and/or wear Laser Enhancement Glass es
(Figure
N
) to help find the beam.
CAUTION:
To reduce the risk of serious injury, never stare
directly into the laser beam with or without
these glasses. Refer to Accessories for
important information.
• Always mark the center of the beam created by the
laser.
• Extreme temperature changes can cause movement
or shifting of building structures, metal tripods,
equipment, etc., which can effect accuracy. Check
your accuracy often while working.
• If the laser has been dropped, check to make sure
your laser is still calibrated. Refer to Checking Laser
Accuracy.
Turning the Laser On
Place the laser on a at level surface. Slide the Power/
Transport Lock switch
C
2
to the right to unlock/turn
ON the laser.
Each laser line is powered on by pressing its button on
the keypad (Figure
C
3
). Pressing the button again
turns the laser line off. The laser lines can be powered
one at a time or all at the same time.
Button Displays
Horizontal laser line (Figure
C
4
)
Side vertical laser line (Figure
C
5
)
Front vertical laser line (Figure
C
6
)
When the laser is not in use, slide the Power/Transport
Lock switch to the left in the OFF/Locked position. If
the Power/Transport Lock switch is not placed in the
lock position, all 4 LEDs will continuously ash on the
Battery Meter.
To Next Page
Loading...
