DeWalt DCM562 User Manual

9
English
Charging Procedure (fig. 2)
1. Plug the charger into an appropriate outlet
before inserting battery pack.
2. Insert the battery pack (F) into the charger.
The red (charging) light will blink continuously
indicating that the charging process has started.
3. The completion of charge will be indicated by
the red light remaining ON continuously. The
pack is fully charged and may be used at this
time or left in the charger.
NOTE: To ensure maximum performance and life of
Li-Ion batteries, charge the battery pack fully before
first use.
Charging Process
Refer to the table below for the charge status of the
battery pack.
Charge indicators: DCB105
charging
–– –– –– –– –– –– ––
fully charged
––––––––––––––––––––
hot/cold pack delay
––– • ––– • ––– • –––
replace battery pack
••••••••••••••
The compatible charger(s) will not charge a faulty
battery pack. The charger will indicate faulty battery
by refusing to light or by displaying problem pack or
charger blink pattern.
NOTE: This could also mean a problem with a
charger.
If the charger indicates a problem, take the charger
and battery pack to be tested at an authorised
service centre.
HOT/COLD PACK DELAY
When the charger detects a battery that is too hot
or too cold, it automatically starts a Hot/Cold Pack
Delay, suspending charging until the battery has
reached an appropriate temperature. The charger
then automatically switches to the pack charging
mode. This feature ensures maximum battery life.
A cold battery pack will charge at about half the rate
of a warm battery pack. The battery pack will charge
at that slower rate throughout the entire charging
cycle and will not return to maximum charge rate
even if the battery warms.
LITHIUM ION BATTERY PACKS ONLY
XR Li-Ion tools are designed with an Electronic
Protection System that will protect the battery
against overloading, overheating or deep discharge.
 • Donotexposechargertorainorsnow.
 • Pullbyplugratherthancordwhen
disconnectingcharger.This will reduce risk
of damage to electric plug and cord.
 • Makesurethatcordislocatedsothatit
willnotbesteppedon,trippedover,or
otherwisesubjectedtodamageorstress.
 • Donotuseanextensioncordunlessit
isabsolutelynecessary.Use of improper
extension cord could result in risk of fire,
electric shock, or electrocution.
 • Donotplaceanyobjectontopofcharger
orplacethechargeronasoftsurfacethat
mightblocktheventilationslotsandresult
inexcessiveinternalheat. Place the charger
in a position away from any heat source. The
charger is ventilated through slots in the top and
the bottom of the housing.
 • Donotoperatechargerwithdamagedcord
orplug— have them replaced immediately.
 • Donotoperatechargerifithasreceived
asharpblow,beendropped,orotherwise
damagedinanyway. Take it to an authorised
service centre.
 • Donotdisassemblecharger;takeittoan
authorisedservicecentrewhenserviceorrepair
isrequired. Incorrect reassembly may result in a
risk of electric shock, electrocution or fire.
 • Incaseofdamagedpowersupplycordthe
supply cord must be replaced immediately by
the manufacturer, its service agent or similar
qualified person to prevent any hazard.
 • Disconnectthechargerfromtheoutlet
beforeattemptinganycleaning.Thiswill
reducetheriskofelectricshock.Removing
the battery pack will not reduce this risk.
• NEVERattempt to connect 2 chargers together.
 • Thechargerisdesignedtooperateon
standard230Vhouseholdelectricalpower.
Donotattempttouseitonanyothervoltage.
This does not apply to the vehicular charger.
SAVE THESE INSTRUCTIONS
Chargers
The DCB105 chargers accepts 18 V Li-Ion DCB180,
DCB181, DCB182, DCB183, DCB184, and
DCB185 battery packs.
D
eW
ALT chargers require no adjustment and are
designed to be as easy as possible to operate.

DeWalt DCM562 Specifications

General

Type	Handheld blower
Power	- W
Noise level	94 dB
Suction mode	-
Product color	Yellow
Carrying handle(s)	Yes
Power source	Battery

Weight and Dimensions

Weight	3200 g