DeWalt DCMST561N - Maintenance, Storage, and Risks; Maintenance and Storage Procedures; Additional Safety for Grass Trimmers; Residual Risks

7
ENGLISH
Residual Risks
In spite of the application of the relevant safety regulations
and the implementation of safety devices, certain residual risks
cannot be avoided. These are:
• Impairment ofhearing.
• Risk of personal injury due to flyingparticles.
• Risk of burns due to accessories becoming hot
duringoperation.
• Risk of personal injury due to prolongeduse.
SAVE THESE INSTRUCTIONS
• Do not operate the appliance in explosive atmospheres,
such as in the presence of flammable liquids, gases
ordust.
• When the appliance is stored or transported in a
vehicle it should be placed in the boot or restrained to
prevent movement following sudden changes in speed
ordirection.
• When not in use, the appliance should be stored in a dry,
well ventilated place out of reach ofchildren.
• Children should not have access to storedappliances.
Safety of Others
• This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for theirsafety.
• Children must be supervised to ensure that they do not
play with theappliance.
• When the appliance is stored or transported in a
vehicle it should be placed in the boot or restrained to
prevent movement following sudden changes in speed
ordirection.
• When not in use, the appliance should be stored in a dry,
well ventilated place out of reach ofchildren.
• Children should not have access to storedappliances.
i ) Always ensure that the ventilation openings are kept
clear ofdebris.
Maintenance and storage
a ) Disconnect the machine from the power supply
(i.e. remove the plug from the mains, remove the
disabling device or removable battery) before
carrying out maintenance or cleaningwork.
b ) Use only the manufacturer’s recommended
replacement parts andaccessories.
c ) Inspect and maintain the machine regularly. Have
the machine repaired only by an authorizedrepairer.
d ) When not in use, store the machine out of the reach
ofchildren.
Additional Safety Instructions for
Grass Trimmers

WARNING: Cutting elements continue to rotate after the
motor is switchedoff.
• Wear long trousers to protect yourlegs.
• Before using the appliance, check that your cutting path
is free from sticks, stones, wire and any otherobstacles.
• Only use the appliance in the upright position, with the
cutting line near the ground. Never switch the appliance on
in any otherposition.
• Move slowly when using the appliance. Be aware that
freshly cut grass is damp andslippery.
• Do not work on steep slopes. Work across the face of slopes,
not up anddown.
• Never cross gravel paths or roads while the appliance
isrunning.
• Never touch the cutting line while the appliance
isrunning.
• Do not put the appliance down until the cutting line has
come to a complete standstill.
• Use only the appropriate type of cutting line. Never use
metal cutting line or fishingline.
• Be careful not to touch the line trimmingblade.
• Keep hands and feet away from the cutting line at all
times, especially when switching on themotor.
• Before using the appliance and after any impact, check
for signs of wear or damage and repair asnecessary.
• Take care against injury from any device fitted for
trimming the filament line length. After extending new
cutter line always return the machine to its normal operating
position before switchingon.
• Close supervision is necessary when the appliance is
used nearchildren.
• This appliance is not intended for use by young or infirm
persons withoutsupervision.
• This appliance is not to be used as atoy.
• Use in a dry location only. Do not allow the appliance to
becomewet.
• Do not immerse the appliance inwater.
• Do not open the body casing. There are not user-serviceable
parts inside
Chargers
DeWALT chargers require no adjustment and are designed to be
as easy as possible tooperate.
Electrical Safety
The electric motor has been designed for one voltage only.
Always check that the battery pack voltage corresponds to the
voltage on the rating plate. Also make sure that the voltage of
your charger corresponds to that of yourmains.
Your DeWALT charger is double insulated in
accordance with EN60335; therefore no earth wire
isrequired.
If the supply cord is damaged, it must be replaced by a
specially prepared cord available through the DeWALT
serviceorganisation.