DeWalt DCMWP500 - Operation; LED Dashboard Indicators; State of Charge Indicator; Handle Folding Indicator

57
ENGLISH
Handle Folding Indicator (Fig. U)
The handle folding indicator
15
will illuminate when the
single touch handle
1
is not engaged in the operating
position when the safety key
6
and battery pack
26
are
installed, and the bail handle
8
is pulled. To clear the handle
folding indicator
15
, refer to the Raise the Single Touch
Handle section inthismanual.
Cutting Load Meter Indicator (Fig. U)
The cutting load meter indicator
14
will illuminate white,
yellow or red when mowing.
• White indicates a low cutting load.
• Yellow indicates a medium cutting load.
• Red indicates a high cutting load. Runtime will be reduced if
there is a prolonged high load while mowing.
Overheat Indicator (Fig. U)
• The overheat indicator
13
will illuminate amber and then
blink when the battery or motor is overloaded during
operation.
• The overheat indicator
13
will illuminate red and then blink
when the module has reached a high temperature.
• To clear the overheat indicator
13
, allow the battery and
mower
to cool down. When cooled, restart the mower and
resume cutting with the mower deck sethigher.
Blade Sharpening Indicator (Fig. U)
The blade sharpening indicator
16
will illuminate when the
blades need service. Sharpen or replace the blades, refer to the
Blade Sharpening section inthismanual.
Blade Reset Button (Fig. U)
NOTE: Ensure the battery pack
26
and safety key
6
areinstalled before attempting to reset.
To clear the blade sharpening indicator
16
, power on the LED
dashboard
12
by pulling and holding the bail handle
8
to
the main handle
4
. Press and hold the blade resetbutton
17
until the blade sharpening indicator
16
turns off .
LED Dashboard Indicators (Fig. A, U)
The control panel
12
contains the state of chargeindicator,
load meter indicator, temperature indicator, handle folding
indicator, blade sharpening indicator and reset button.
State of Charge Indicator (Fig. U)
The DCMWP500 and DCMWSP550 are equipped with a state
of charge indicator. This will display the current level of charge
in the battery during use. It does not indicate tool functionality
and is subject to variation based on product components,
temperature and end-userapplication.
• The state of charge indicator LEDs
18
will illuminate,
indicating the percent of charge in the battery.
• When all 5 state of charge indicator LEDs
18
illuminate, the
battery is fully charged.
• When one state of charge indicator LED
18
illuminates,
charge is low and then it will flash when the battery
isdischarged. Remove thebattery and charge it.
State of Charge Indicator LED Status
LEVEL OF CHARGE
CHARGE INDICATOR
LED COLOR
100% ‑ 85% White
70% ‑ 85% White
50% ‑ 70% White
25% ‑ 50% White
≤25% White
Low battery shutdown White and blinking

DANGER: Rotating blades can cause serious injury.
To prevent serious injury, turn unit off and remove safety
key and battery pack when unattended, or when charging,
cleaning, servicing, transporting, lifting, or storingmower.
1. Insert safety key
6
into the key slot
50
, located on the main
handle
4
, until it is fully seated inside of the keyslot
50
as
shown in Fig. T.
2. The mower is now operational.