ENGLISH
2
DCR028 Jobsite Bluetooth® Radio
The DCR028 Jobsite Bluetooth® Radio is an AM/FM radio.
The DCR028 can be powered by 120V AC power source as
well as all
12V MAX*, 20V MAX*, and FLEXVOLT
Li-Ion battery packs. Batteries soldseparately.
SAVE ALL WARNINGS AND
INSTRUCTIONS FOR FUTURE
REFERENCE
Important Safety Instructions
WARNING: Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
seriousinjury.
1 . Read theseinstructions.
2 . Keep theseinstructions.
3 . Heed allwarnings.
4 . Follow allinstructions.
5 . Do not use this apparatus nearwater.
6 . Clean only with a drycloth.
7 . Do not block any ventilation openings. Install in
accordance with the manufacturer’sinstructions.
8 . Do not install near any heat sources such as radiators,
heat registers, stoves or other apparatus (including
amplifiers) that produceheat.
9 . Do not defeat the safety purpose of the polarized
or grounding-type plug. A polarized plug has two
blades with one wider than the other. A grounding
type plug has two blades and a third grounding
prong. The wide blade or the third prong are
provided for your safety. If the provided plug does not
fit into your outlet, consult an electrician for replacement
of the obsoleteoutlet.
10 . Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from theapparatus.
11 . Do not operate the apparatus with a damaged cord
orplug.
12 . Only use attachments/accessories specified by
themanufacturer.
13 . Unplug this apparatus during lightning storms or when
unused for long periods oftime.
14 . Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug
is damaged, liquid has been spilled or objects have fallen
into the apparatus, the apparatus has been exposed
to rain or moisture, does not operate normally, or has
beendropped.
15 . Apparatus shall not be exposed to dripping or splashing
and no objects filled with liquids, such as vases, shall be
placed on the apparatus
WARNING: To reduce the risk of fire or electric shock,
do not expose this apparatus to rain or moisture. Use
only in drylocations.
The label on your tool may include the following symbols. The
symbols and their definitions are asfollows:
V ......................... volts
Hz .......................hertz
min ..................... minutes
or DC ......direct current
...................... Class I Construction
(grounded)
…/min ..............per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................watts
or AC ...........alternating current
or AC/DC .... alternating or
direct current
...................... Class II
Construction
(double insulated)
n
o
.......................no load speed
n .........................rated speed
......................earthing terminal
.....................safety alert symbol
.....................visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
BATTERIES AND CHARGERS
The battery pack is not fully charged out of the carton.
Before using the battery pack and charger, read the
safety instructions below and then follow charging
proceduresoutlined. When ordering replacement battery
packs, be sure to include the catalog number andvoltage.
Your tool uses a
charger. Be sure to read all safety
instructions before using your charger. Consult the chart
at the end of this manual for compatibility of chargers and
batterypacks.
READ ALL INSTRUCTIONS
Important Safety Instructions for All
Battery Packs
WARNING: Read all safety warnings and all
instructions for the battery pack, charger and
power tool. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or seriousinjury.
• Do not charge or use the battery pack in explosive
atmospheres, such as in the presence of flammable
liquids, gases or dust. Inserting or removing the battery
pack from the charger may ignite the dust orfumes.
• NEVER force the battery pack into the charger. DO
NOT modify the battery pack in any way to fit into
a non-compatible charger as battery pack may
rupture causing serious personal injury. Consult
the chart at the end of this manual for compatibility of
batteries andchargers.
• Charge the battery packs only in designated
chargers.
• DO NOT splash or immerse in water or otherliquids.
• Do not store or use the tool and battery pack in
locations where the temperature may reach or
exceed 104°F (40°C) (such as outside sheds or metal