DeWalt DCS365N User Manual

DCS365

DeWalt DCS365N Specifications

General

Type	Circular Saw
Blade Diameter	184 mm
Battery Voltage	18 V
Bore Size	16 mm
Battery Type	Li-ion
Bevel Capacity	50°

Summary

Technical Data and Safety

Definitions: Safety Guidelines

Explains signal words used for safety warnings and their severity levels.

GENERAL POWER TOOL SAFETY WARNINGS

Provides essential safety advice for operating power tools to prevent injury.

Work Area Safety

Guidelines for maintaining a safe and hazard-free environment while operating power tools.

Personal Safety

Advice on maintaining personal alertness and using protective measures during tool operation.

Battery and Charger Safety

Safety Instructions for Mitre Saws

Specific safety precautions and warnings for operating mitre saws safely.

Electrical Safety

Further electrical safety precautions, including mains plug replacement.

Important Safety Instructions for All Battery Chargers

Critical safety information and operating instructions for DEWALT battery chargers.

Battery Pack Operation and Charging

Battery Packs

Comprehensive safety guidelines for handling and using DEWALT battery packs.

Charging a Battery (Fig. D)

Step-by-step instructions for charging DEWALT battery packs using the charger.

Electronic Protection System

Describes the tool's protection system that prevents overload and deep discharge.

Tool Identification and Features

Intended Use

Specifies the intended applications and purpose of the DEWALT DCS365 mitre saw.

Saw Operation Basics

Instructions for Use

General instructions and guidelines for operating the DEWALT mitre saw safely and effectively.

Proper Body and Hand Position (Fig. G1-G4)

Illustrates correct body posture and hand placement for safe saw operation.

Trigger Switch (Fig. H)

Explains the function and operation of the saw's trigger switch.

Dust Extraction (Fig. A, I)

Cutting with your Saw (Fig. A)

Straight Cut (Fig. A, G1, G2)

Mitre Cuts (Fig. J, K)

Bevel Cuts (Fig. L1, L2)

Clamping the Workpiece

Adjustments and Project Cutting

ADJUSTMENTS

Mitre Scale Adjustment (Fig. J, N)

Bevel Square to Table Adjustment (Fig. A, L1, 0)

Guard Actuation and Visibility (Fig. A, X)

Support for Long Pieces

Cutting Compound Mitres (Fig. R)

Material Cutting and Maintenance

Cutting Base Molding (Fig. S)

Cutting Crown Molding (Fig. T, U)

Special Cuts

Bowed Material (Fig. V, W)

Cutting Large Material (Fig. X)

MAINTENANCE

Troubleshooting and Battery Care

Troubleshooting Guide