10. Turn the engine ON/OFF switch (H) to the ON position.
11. Place the fuel valve lever (M) in the ON postion.
12.
If the engine is cold, move the choke (K) to the CLOSED position
as shown.
M
H
K
13. WARNING:
until resistance is felt. Then pull starter grip (I) rapidly to avoid
NOTE: Do not allow the starter grip to snap back. Return it gently
by hand.
WARNING:
starter cord slowly until resistance is felt. Then pull cord rapidly to
NOTE: If the oil level in the engine is low, the engine will not start.
If the engine does not start, check the oil level and add oil as
needed.
14. As the engine warms up, move the choke
K
to the OPEN position.
15. Depress trigger on gun to start water
flow.
WARNING:
on a stable surface and grip gun/wand firmly
when triggered.
16. Release trigger to stop water flow.
DANGER:
X
accidental spraying.
17. Adjust spray for the task being performed
by changing quick connect nozzle. Refer to
Spray Wand Nozzles.
Shutting Down
1. If chemicals were applied, place the chemical hose into a
container of clean water and draw clean water through chemical
injection system to rinse system thoroughly.
NOTICE: property damage Failure to do so could cause
damage to the pump.
2. Place the engine ON/OFF switch (H) to the OFF Position.
3. Place the fuel valve lever (M) in the OFF
M
postion.
NOTICE:
turn water supply off while pressure washer
engine is running or damage to pump will
result.
4. Turn water source off.
5. Pull trigger on spray gun to relieve any water pressure in hose or
spray gun.
6. Refer to Storage for proper storage procedures.
Maintenance
WARNING: burning. When performing maintenance, you
may be exposed to hot surfaces, water pressure or moving parts that
To Next Page
Loading...
Need help?
General
