DeWalt DW030 - Page 48

english
46
ASSEMBLY AND ADJUSTMENTS
WARNING! Donotplacethelaserinapositionwhich
maycauseanyonetointentionallyorunintentionally
stareintothelaserbeam.Seriouseyeinjurymayresult
from staring at the beam.
Installing and Removing Battery (fig. 2)
NOTE: This LDM is powered by two LR03 (AAA-size) 1.5 V
DC
batteries.
INSTALLING THE BATTERY PACK
1. Lift up the battery compartment cover (a) as shown in figure 2.
2. Insert two LR03 (AAA-size) batteries into the compartment, placing
the batteries according to + and – icons on the inside of the
compartment.
NOTE: When the battery icon flashes in the LCD display, replace
battery with 2 fresh LR03 (AAA-size) batteries.
Attachment of Wrist Strap (fig. 3)
Refer to figure 3 for instructions.
OPERATION
WARNING! Donotplacethelaserinapositionwhich
maycauseanyonetointentionallyorunintentionally
stareintothelaserbeam.Seriouseyeinjurymayresult
from staring at the beam.
Instructions for Use
WARNING: Always observe the safety instructions and
applicable regulations.
CAUTION: Useofcontrolsoradjustmentsorperformance
of procedures other than those specified herein may result
inhazardousradiationexposure.