ENGLISH
en - 4 24
The applications range from drop-ceiling installation
and wall layout to foundation leveling and deck
building.
The tool accepts DEWALT battery packs of 9.6, 12,
14.4 and 18 V.
1 Variable speed switch
2 Bump sensor reset button
3 Bump sensor activation button
4 Carrying handle
5 Base leveling knob
6 Base
7 Laser head rotation button
8 Rotary laser head
9 Front air level
10 Front level adjustment knob
11 Wall mount clamp
12 Wall mount clamp lock
13 Rack pinion wheel
14 Head position lever
15 Battery pack
16 Rack pinion locking knob
17 Side level adjustment knob
18 Side air level
Charger
Your DE9108 charger accepts DEWALT NiCd
battery packs ranging from 7.2 V to 18 V.
Your DE9116 charger accepts DEWALT NiCd and
NiMH battery packs ranging from 7.2 V to 18 V.
19 Release buttons
20 Charger
21 Charging indicator (red)
Electrical safety
The electric motor has been designed for various
voltages (see technical data). Always check that the
battery pack power corresponds to the voltage on
the rating plate. Also make sure that the voltage of
your charger corresponds to that of your mains.
Your DEWALT charger is double
insulated in accordance with EN 60335.
Mains plug replacement
(U.K. & Ireland only)
• Should your mains plug need replacing and you
are competent to do this, proceed as instructed
below. If you are in doubt, contact an authorized
DEWALT repair agent or a qualified electrician.
• Disconnect the plug from the supply.
• Cut off the plug and dispose of it safely; a plug
with bared copper conductors is dangerous if
engaged in a live socket outlet.
• Only fit 13 Amperes BS1363A approved plugs
fitted with the correctly rated fuse (1).
• The cable wire colours, or a letter, will be marked
at the connection points of most good quality
plugs. Attach the wires to their respective points
in the plug (see below). Brown is for Live (L) (2)
and Blue is for Neutral (N) (4).
• Before replacing the top cover of the mains plug
ensure that the cable restraint (3) is holding the
outer sheath of the cable firmly and that the two
leads are correctly fixed at the terminal screws.
Never use a light socket.
Never connect the live (L) or neutral (N)
wires to the earth pin marked E or .
Using an extension cable
An extension cord should not be used unless
absolutely necessary. Use an approved extension
cable suitable for the power input of your charger
(see technical data). The minimum conductor size is
1 mm
2
; the maximum length is 30 m.
Assembly and adjustment
Prior to assembly and adjustment,
always remove the battery pack.
• Always switch off the tool before
inserting or removing the battery pack.
• Use only DEWALT battery packs and
chargers.
To Next Page
Loading...
