• Never reach under the tool for any reason unless it is turned off
and UNPLUGGED. BLADES ARE EXPOSED AND EX-
TREMELY SHARP.
• Use this tool for working with wood and wood products only.
• Never operate without securely holding the front handle.
• Always operate planer with two hands.
• Planer blades are extremely sharp - Handle with great care.
CAUTION: Some wood contains preservatives such as copper
chromium arsenate (CCA) which can be toxic. When
sanding,drilling, or cutting these materials extra care should be
taken to avoid inhalation and minimize skin contact.
• The label on your tool may include the following symbols.
V..........................volts
A..........................amperes
Hz........................hertz
W ........................watts
min ......................minutes
........................alternating current
....................direct current
n
o ........................no load speed
........................
Class II Construction
…/min..................revolutions or reciprocation per minute
........................earthing terminal
........................safety alert symbol
SAVE THESE INSTRUCTIONS
Motor
Be sure your power supply agrees with nameplate marking.
120 volts AC only means your tool may be operated only with
alternating current and never with direct current.
2
English
TRIGGER
LOCKING
BUTTON
CHIP DISCHARGE
CHUTE – KEEP
CLEAR
ROTATE CLOCKWISE
TO INCREASE
CUTTING DEPTH
FIG. 1
FIG. 2
FIG. 3
DW677, DW680
DW678
To Next Page
Loading...
