DeWalt DW840 - Fitting and Removing the Guard (DW840)

English
11
Wire Wheels
3" (76.2mm)
wire cup brush
Type 27 guard
rubber backing pad
sanding disc
threaded clamp nut
Sanding Discs (DW831)
Sanding Flap Discs
Type 27 guard
unthreaded backing flange
non-hubbed sanding flap disc
4" (101.6mm)
wire wheel
Type 27 guard
WARNING: DW840 cannot be
used with conventional sanding
discs and backing pads due to
mismatched rated speeds.
CAUTION: Use a Type 27 guard with wire brushes and wheels. Operators and others in the area should wear appropriate eye, face
and body protection. Strands of wire may break and fly off when wire wheels and brushes are in use.
CAUTION: Type 1 abrasive and diamond cut-off wheels may not be used on this tool. A Type 1 cut-off wheel guard is not available
for these grinders.
hubbed sanding
flap disc
Type 27 guard
threaded locking flange