English
16
TYPE OF MATERIAL TO BE CUT SPEED RANGE
Solid wood (hard, soft) 3–5
Chipboards 4–5
Laminated wood, blockboards,
veneered and coated boards
2–5
Paper and carton 1–3
Wall Cutting (Fig. 12)
1. Place the track saw with the outer guard (V) on a clean, fl at fl oor.
D
V
12mm
FIG. 12
2. Press the shoe (D) with the front side on the wall against the
adjusted depth stop.
NOTE: The minimum cut between wall and workpiece is 12mm.
Dust Extraction (Fig. 1)
WARNING: DO NOT direct sawdust toward yourself or others. To
avoid injury from fl ying sawdust, keep the exhaust nozzle either in the
forward position or in the closed position. DO NOT insert foreign
objects into the exhaust opening.
WARNING: ALWAYS connect the track saw to a dust extractor!
WARNING: ALWAYS use a dust extraction device designed in
accordance with the relevant regulations regarding dust emission.
Your tool is fi tted with a dust extraction outlet (I).
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect it from power source before installing and removing
accessories, before adjusting or when making repairs. An
accidental start-up can cause injury.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning
the non-metallic parts of the tool. These chemicals may weaken the
plastic materials used in these parts. Use a cloth dampened only with
water and mild soap. Never let any liquid get inside the tool; never
immerse any part of the tool into a liquid.
Lubrication
This tool has been lubricated with a suffi cient amount of high grade
lubricant for the life of the unit under normal operating conditions. No
further lubrication is necessary.
Motor Brushes
WARNING: To reduce the risk of injury, DO NOT TIE, TAPE, OR
OTHERWISE LOCK THE ON/OFF SWITCH ON while “running in”.
HOLD BY HAND ONLY.
DEWALT uses an advanced brush system that automatically stops the
saw when the brushes wear out. This prevents serious damage to the
motor. Brush systems can be replaced at authorized DEWALT service
centers.
Accessories
WARNING: Since accessories, other than those offered by DEWALT,
have not been tested with this product, use of such accessories with
To Next Page
Loading...
Need help?
General
