EasyManua.ls Logo

DeWalt DXFRS220 - Battery Information; Charging and Battery Care; Operation and Quick Start; Using Your Radio

DeWalt DXFRS220
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1 2
Operation
Using Your Radio
Quick Start
1. Press and hold Power/Menu button for 4 seconds to turn the radio
on or off.
2. Select a desired channel.
3. Press and hold the Talk button while speaking into the microphone.
4. When nished talking, release the Talk button and listen for a
response.
Both radios must be tuned to the same
channel/privacy code to communicate.
Caring for Your Radio
Your radio will give you years of trouble-free service if cared for properly.
Handle the radio gently. Keep the radio away from dust. Never put the radio in
water or in a damp place. Avoid exposure to extreme temperatures.
Battery Information
The battery is not charged before delivery, so please charge the battery for
your rst use. If the battery is not used for a long time or the battery is used up,
please charge it before use. Charge / discharge for twice or three times
alternately to achieve its optimal performance.
Note:
• Do not cause any short circuit on the battery or throw the battery into re.
• When charging, please make sure the radio is powered off to guarantee it
can be fully charged.
• Unplug the charging cable after it is fully charged. Unnecessary constant
charging will shorten the battery life.
• Do not put the fully-charged battery to re-charge, or it may shorten the
battery life.
• Please try to keep the battery in an indoor environment at around 25°C. The
battery may get easily spoiled after being kept in the environment below
-10°C for a long time.
• In temperatures higher than 35°C or below -10°C, the dischargeable power
of the battery may decrease due to the physical property of lithium battery.
For charging radio(s):
1. Insert the micro-USB cable into jack located at the bottom of radios.
2. Plug the cable into USB compatible power port.
3. It will take around 5 hours for a full charge.
4. LED indicator
D
EWALT recommends your radio be turned off while being charged.
Power Off the Device during charging
Battery Charging Solid Red (No ash)
Battery Charged Solid Green (No ash)

Related product manuals