11 12
Vibration Alert and Call Alert
Your radio can alert you to incoming signals by sounding an audible call
tone or an audible tone with Vibration Alert.
To change call settings:
1. Press the Mode button until the Call Setting icon is
shown on the display. The current setting (“0”
ring only, “1” vibrate + ring) is displayed.
2. Press the Up or Down button to
change the call setting.
3. Choose one of the following:
a. Press the Mode button to enter the new setting
and proceed to other functions.
b. Press Talk or Call/Lock button to return to
Standby mode.
c. Do not press any buttons for 6 seconds to
return to Standby mode.
Note: Vibration Alert will be suspended during charging
Roger Beep Confirmation Tone
Your listener will hear an audible tone when you release the Talk button.
This alerts the other party that you have finished talking and it is OK for
them to speak.
Key Tone
Key Tone is an audible tone which will sound each time a button is
pressed.
NOTE: Both Roger Beep and Key Tone can be toggled (Enabling or
Disabling) as following.
To turn both Roger Beep and Key Tone on or off:
1. Turn OFF the radio.
2. Press and hold the Call/Lock button, and then turn ON the radio at the
same time, tones enabling or disabling confirmation would be heard.
3. Release the Call/Lock button.
Call Tone On/
Vibrate Off
Call Tone On/
Vibrate On
Operation
General Specifications
Frequency Allocation and Compatibility
A = Channel No. for 22 Channel Models
B = Frequency in MHz
C = Power Output
A B C
1 462.5625 High
2 462.5875 High
3 462.6125 High
4 462.6375 High
5 462.6625 High
6 462.6875 High
7 462.7125 High
8 467.5625 Low
9 467.5875 Low
10 467.6125 Low
11 467.6375 Low
12 467.6625 Low
13 467.6875 Low
14 467.7125 Low
15 462.5500 High
16 462.5750 High
17 462.6000 High
18 462.6250 High
19 462.6500 High
20 462.6750 High
21 462.7000 High
22 462.7250 High
IMPORTANT NOTICE:
Changes or modifications to this unit not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1) This device may not cause harmful interference, and 2) this device must accept any
interference received,including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
To Next Page
Loading...
